Post subject: 1.8T AEB GT2871r Ignition Timing - 034EFI Stage Ic
Posted: Sat Aug 20, 2016 9:17 pm
Stuck in first
Joined: Sat Jun 18, 2011 12:23 am Posts: 9
I'm about to rebuild my 1.8t AEB engine after I threw a rod running 20psi on my GT2871r. After disassembling the engine I noticed the other 3 rods had slight bends/warps in them. I can now appreciate why everyone says to replace the rods before attempting to make decent power!!!
I've sent the AEB head and new block (from new motor) away to my cylinder head machinist and everything looks good apart from the exhaust valve guides which require replacing.
My current tune pulled well but I'm now a little wary as I don't wish to blow another engine after I rebuild it with SCAT rods. As my car is in bits at the moment, I'm unable to download my tune and upload my current timing figures but I'm wondering if anyone would be able to look at my gear and perhaps send me through some tuned timing figures?
034EFI Stage Ic 4bar MAP sensor GT2871r turbo 550cc Injectors (fueling no probs - sits around 11:1 peak boost WOT) Stock pistons Stock head Stock block/crank SCAT rods
Hoping to run around 20psi or more on 98 octane here in Australia.
Users browsing this forum: No registered users and 1 guest
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum