Automobiles Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
288 Posts
P1020713.JPG

P1020712.JPG

these are pictures of the left front of my Cq that I'm rebuilding into a S2.

Can some one tell me if the frame rail are bent?
 

Attachments

·
Registered
Joined
·
12,840 Posts
measure the front frame horn ends, bolt center to center and I can compare to my straight shell for ya
 

·
Registered
Joined
·
288 Posts
Discussion Starter · #3 ·
the front horn ends are lined up width wise cause I have the snub mount cross bar on the car. I think it's pushed in toward the fire wall
so I measured from the inside of the engine mount closest to the frame to the front horn end and it's 1'7/16".
 

·
Registered
Joined
·
12,840 Posts
you can put a piece of flat stock on the frame horn ends to check their squarness and length
 

·
Registered
Joined
·
288 Posts
Discussion Starter · #5 ·
will do
 

·
Registered
Joined
·
288 Posts
Discussion Starter · #7 ·
that what I thought.
 
1 - 7 of 7 Posts
Top