Automobiles Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,532 Posts
Discussion Starter · #1 ·
Its been a very long time since I've been on here and even longer since I touched any of my cars... Its time and im missing them so first on the list is the audi. Its currently on vems using the factory crank trigger. 034 coil pack kit.

It has an itermittent issue that I believe is ignition related. The car starts and runs fine (cranks a bit to find signal) but when it warms up it bucks hard and the tach jumps all over the place at low rpm under load. I was thinking it is the crank position sensor, but I am not sure. Any thoughts?
 

·
Registered
Joined
·
1,897 Posts
Have you checked ECU fault codes?
 

·
Registered
Joined
·
1,532 Posts
Discussion Starter · #3 ·
Have not, but I'm not sure how to do that on VEMS. Ill have to check into it.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top