Automobiles Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5,020 Posts
Discussion Starter · #1 ·
We purchased an AAN ecu with adjustable VMAP installd, and are trying to find out some info on how to set it. Here is the pic if anyone has some info to share it would be greatly appreciated thanks>
 

Attachments

·
Registered
Joined
·
133 Posts
I think I have one of those in my car as well and finding info wasn't very straightforward. They were sold by moreboost.com which is gone now. I found the install and settings info using the "wayback machine" at http://web.archive.org to view a cached version of the old moreboost site.
 

·
Registered
Joined
·
5,020 Posts
Discussion Starter · #3 ·
Thanks that was very helpful!. The pics don't show anymore but we will try to figure out from the text how to arrange the jumper
 

·
Registered
Joined
·
57 Posts
Orient your computer so that the computers connector pins are on the left side and the map sensor is in the top left of the board. On the map sensor, you will see two sets of jumper pins. The first set on the left front of the map has 4 pins, the second set to the right of that has 5 sets of pins. In the set which contains 5 pins the first pin on the left is pin number one, bosch mode. If you want to set three bar for example, you would set pin number 1, pin number 3, and pin number 5. Pin number 5 is the one all the way to the right.
 

·
Registered
Joined
·
57 Posts
In this image, you will see pins 1, 3, & 5 set for 3bar.
 

Attachments

1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top