Automobiles Forum banner
1 - 20 of 24 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
It is a 91, not currently selling the motor, subframes, exhaust, fog lights, radiator or suspension/ subframes. Sunroof glass is good but rusty and missing controls. Gray leather interior is good, drivers seat bottom has rip. Rear bumper is good, so are corner tails (center is cracked) doors and hatch are straight and so is drivers fender. All are faded, some asshat resprayed the doors forward with a clear that is pealing badly. Window motors are both good. See pics, ask questions, make offers. Located in Beallsville PA 15313. Also selling a good set of B3 80/90 fogs.















B3 Fogs
 

·
Registered
Joined
·
4,648 Posts
Besides the obvious bad, what is actually wrong with the car? I know of a few people looking for a project CQ.
 

·
Registered
Joined
·
56 Posts
Discussion Starter · #3 ·
Why am I parting. I was under the impression you either part a cq or make it an S2 clone.

My room mate and I pulled it from a used car/ mechanic lot. It has sat there for over 6 years. We had to brake the rear rotors to get it to roll. The head was supposedly rebuilt 3k miles before it was parked with a bad fuel pump. Also got new H&R shocks and springs and a CAC muffler at the same time. The suspension parts along with the rear sub frame, diff and exhaust are going on his cq. I'm keeping the 2 piece struts and speedlines for my 4kq. The owner took a job in SF and left it at the shop. The engine and transmission will be for sale once pulled, hopefully tomorrow.
 

·
Registered
Joined
·
4,648 Posts
Can you post some more pics of the fogs? In that pic it looks like at least 1 of the mounting tabs is missing.
 

·
Registered
Joined
·
12,838 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #10 ·
Tim!! The drivers fender is already at Tay's. The passenger is a little rough around the edges. Neither is perfect, but both are pretty straight. What are you using them for? What happened to those 4kq transmission cups?
 

·
Registered
Joined
·
12,838 Posts
Alpine87.5 said:
Tim!! The drivers fender is already at Tay's. The passenger is a little rough around the edges. Neither is perfect, but both are pretty straight. What are you using them for? What happened to those 4kq transmission cups?
cq spares, I have the cups here
 

·
Registered
Joined
·
56 Posts
Discussion Starter · #13 ·
7a is out and ready to be sold as one unit. $500 with everything attached. 160k on it. Prefer local pick up. If it does not sell as a whole unit then I will part it out. 91 subframes will be pulled soon and sold. Strut housings will not be sold. H&R springs are also out and ready to be sold, $150. Will post pics tomorrow, too tired now.
 
1 - 20 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top