motorgeek.com
https://www.motorgeek.com/

CQ rear wiper arm cap DIY 3D print
https://www.motorgeek.com/viewtopic.php?f=13&t=219107
Page 1 of 1

Author:  jonas-k [ Mon Nov 02, 2020 11:28 am ]
Post subject:  CQ rear wiper arm cap DIY 3D print

So I've been missing the rear wiper arm cap on my CQ for many years. I decided to make my own. I had it printed in nylon. Not perfect but good enough for me and I may sand/smooth it out later.

https://www.thingiverse.com/thing:4632340

Attachments:
image5.jpg
image5.jpg [ 750.12 KiB | Viewed 171 times ]
image4.jpg
image4.jpg [ 535.13 KiB | Viewed 171 times ]

Author:  imdstig [ Mon Nov 02, 2020 12:50 pm ]
Post subject:  Re: CQ rear wiper arm cap DIY 3D print

Nice mine is missing as well. I will need to try this Thank you

Author:  PRY4SNO [ Sat Nov 07, 2020 12:30 pm ]
Post subject:  Re: CQ rear wiper arm cap DIY 3D print

Well done, Jonas. You're really bringing some (sorely needed) enthusiasm back to the small chassis crowd. Keep it up!

Author:  jonas-k [ Sun Nov 08, 2020 10:26 am ]
Post subject:  Re: CQ rear wiper arm cap DIY 3D print

PRY4SNO wrote:
Well done, Jonas. You're really bringing some (sorely needed) enthusiasm back to the small chassis crowd. Keep it up!


Thanks for the kind words. I love it when old hobbies (cars/gearhead) mingle with new hobbies (CAD/3D printing). Some say I have too many hobbies.

Jonas
90 CQ (3B, K26/K27 hybrid, VEMS)
07 S8 (Stock)

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/