Automobiles Forum banner

Tims 90CQ Project

11K views 80 replies 14 participants last post by  vinniepearl 
#1 ·
Hello everyone.

I purchased a 90 cq about two months back and I have big plans for the car. However it will move a long slowly due to money and time. So far I have picked up a 7a short block from Peter with 150k miles.

I bought a pair of dm forged h beams and je forged 82.5mm pistons.
My goal is 600 whp.

Plans:
Built block
01e swap
Stripping down interior and overall weight reduction on the car. Race seats and a roll cage.

Here are some starting pics and I'll upload more as I go.





 
See less See more
5
#78 ·
varia said:
that radiator, fan, shroud and lack of ducting is looking insufficient
I plan on making some ducting. There's a few guys on the s2 forum that use these radiators for weekend fun toys. Worst case scenario I install the bigger radiator. I also thought about possibly installing a secondary front mount radiator above the intercooler.

Sent from my SM-G892A using Tapatalk
 
#79 ·
New fuel system installed and I adjusted afr at idle. She idles much better now. Just need to weld in flex pipe and I can start driving and tuning.



Battery was a little low but I got to play with my horn.



Sent from my SM-G892A using Tapatalk
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top